BLOCKS

*NYLON TRAP PULLEYS*
	FOLBE OPEN FACED BLOCK EASES MANUAL RETRIEVAL OF POTS LOAD LIMIT - 700 LBS DEAD WEIGHT HEAVY DUTY NYLON CONSTRUCTION 8-1/4" OVERALL - ROLLER IS 1" WIDE ONLY $49.99

LOOMIS TROLLING BLOCKS
CLOSED HEAVY DUTY NYLON BLOCK PULLEY
~~~~~~~~~~~~
Loomis rope sheave trolling blocks have an improved self-lubricating Oilite bushing system. Special materials are used to create a low friction, low wear surface that is virtually indestructible under normal use. 1,500 pound break test corrosion resistant swivel. The reinforced nylon, four inch block has been lab tested to 3,700 pounds not including swivel, and the six inch block tested at an incredible 5,800 pounds not including swivel.
~~~~~~~~~~~~
4" BLOCK $35.99 6" BLOCK $40.99

CUSTOM SEA GEAR BLOCKS

100% stainless steel construction. Hardened 4" sheave, swivel eye, stainless steel grease fitting and ball bearing. Available with a "V" or a "U" grooved sheave. "V" Groove recommended for use with cable or monofilament, "U" groove for use with rope.

OPEN FACE = $175.00 CLOSED FACE = $166.00

Block Weight: 5 lbs/Box size: 10"x10"x4"

4" Super Block - Alum Roller
High or Low Lip ~ $188.00
4" Super - 304 Stainless Roller
High or Low Lip ~ $210.00
5’’ Super Block - Alum Roller
High or Low Lip ~ $208.00
5" Super Block - 304 Stainless Roller
High or Low Lip ~ $287.00
5" Super Block - All Stainless
High Lip Only ~ $465.00 (37-lbs)

Aluminum main frame and end plate. Blocks have sealed taper steel roller bearings packed in hydraulic oil! 3/8" x 4-1/2" bolts on the 4" Blocks, 3/8" x 6" on the 5" blocks.

STAINLESS STEEL HOOK WITH STAINLESS STEEL GREASE FITTING! DESIGNED TO BE MAINTENANCE FREE WITH PRE-GREASED SEALED TAPERED ROLLER BEARINGS THAT DON'T REQUIRE FURTHER GREASING!

4" Super Low Lip

4" Super High Lip

5" Super Low Lip

5" Super High Lip

4" Super Blocks have an overall height of 14-1/2", with a working roller width of 2-1/3". Height of hanging point to warp is 8-1/2". Holding capacity is 2,000 lbs.

5" Super Blocks have an overall height of 16", with a working roller width of 4-1/4". Height of hanging point to warp is 9-3/4". Holding capacity is 2,000 lbs.