Step 1: Lower the fishing light about two feet into water.  Placing the light just below the waters surface creates a mirror effect when the light reflects off the top off the waters surface and shines downward again. Also, if you lower the light to deep the fish may tangle around the lights power-cord when reeling them in.  

Step 2: Connect red battery clip to positive (+) battery post, then connect black battery clip to negative (-) battery post, chassis or engine block.

Step 3: When done fishing, remove the red battery clip from positive (+) battery post, then remove black battery clip from negative (-) battery post, chassis or engine block.

Step 4: Let the light cool down and remove it from the water.

Note: To prevent water leakage into the light, occasionally check to make sure the tube stopper has not worked itself loose. (See Bulb/Globe/Tube Guard Replacement Guide below).

The light must be submerged in water before attaching battery clips to battery terminals. Do not remove light from water until battery clips have been removed from battery and light has  cooled down. Use cation when handling and storing the light. The globe is fragile and easily broken.

Do not operate the light if there is water in the quartz tube.  Fog inside the tube without water is normal. Keep battery clips out of the water and dry at all times.

Do not allow children to operate this fishing light. Do not use this light in the close proximity of combustible or flammable materials. Do not attempt to operate the fishing light if any part of the light is damaged.

Do not attempt to make your own repairs or adjustments. Do not connect the fishing light to a battery of an inboard boat, before first
activating the blower. Do not use this product for anything other than what it is designed for.

FAILURE TO ADHERE TO THE SAFETY WARNINGS AND GUIDELINES IN THIS MANUAL COULD RESULT IN  BODILY INJURY OR PROPERTY DAMAGE.